自分がやっていることに満足していますか。自分のレベルを高めたいですか。では、仕事に役に立つスキルをもっと身に付けましょう。 あなたは各バーションのCiscoの350-401参考書内容試験の資料をダウンロードしてみることができ、あなたに一番ふさわしいバーションを見つけることができます。暇な時間だけでCiscoの350-401参考書内容試験に合格したいのですか。 実際にはそれは全く不要です。

はやくRadiatoripermotoriの350-401参考書内容問題集を入手しましょう。

競争力が激しい社会に当たり、我々Radiatoripermotoriは多くの受験生の中で大人気があるのは受験生の立場からCisco　350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)参考書内容試験資料をリリースすることです。 RadiatoripermotoriのCiscoの350-401 試験解説問題の試験問題と解答は当面の市場で最も徹底的な正確的な最新的な模擬テストです。煩わしいCiscoの350-401 試験解説問題試験問題で、悩んでいますか？悩むことはありません。

数年以来の整理と分析によって開発された350-401参考書内容問題集は権威的で全面的です。350-401参考書内容問題集を利用して試験に合格できます。この問題集の合格率は高いので、多くのお客様から350-401参考書内容問題集への好評をもらいました。

CiscoのCisco 350-401参考書内容試験への復習に悩んでいますか。

どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。ITの専門者はCiscoの350-401参考書内容認定試験があなたの願望を助けって実現できるのがよく分かります。Radiatoripermotoriはあなたの夢に実現させるサイトでございます。

我々のCiscoの350-401参考書内容ソフトはあなたのすべての需要を満たすのを希望します。問題集の全面性と権威性、Ciscoの350-401参考書内容ソフトがPDF版、オンライン版とソフト版があるという資料のバーションの多様性、購入の前にデモの無料ダウンロード、購入の後でCiscoの350-401参考書内容ソフトの一年間の無料更新、これ全部は我々の誠の心を示しています。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

BOMI International CAP-2101-20 - 模擬テスト問題集と真実の試験問題がよく似ています。 APA CPP-Remote - 我々の商品にあなたを助けさせましょう。 RadiatoripermotoriのCiscoのABPMP CBPAの試験問題は同じシラバスに従って、実際のCiscoのABPMP CBPA認証試験にも従っています。 初心者といい、数年IT仕事を従事した人といい、我々RadiatoripermotoriのCisco　BOMI International CAP-2101-20問題集は最良の選択であると考えられます。 CiscoのPECB ISO-9001-Lead-Auditor-JPN認定試験に受かるのはあなたの技能を検証することだけでなく、あなたの専門知識を証明できて、上司は無駄にあなたを雇うことはしないことの証明書です。

Updated: May 28, 2022