Radiatoripermotori Ciscoの350-401資格難易度試験トレーニング資料というのは一体なんでしょうか。Ciscoの350-401資格難易度試験トレーニングソースを提供するサイトがたくさんありますが、Radiatoripermotoriは最実用な資料を提供します。Radiatoripermotoriには専門的なエリート団体があります。 あなたのCiscoの350-401資格難易度認証試験に合格させるのはRadiatoripermotoriが賢明な選択で購入する前にインターネットで無料な問題集をダウンロードしてください。そうしたらあなたがCiscoの350-401資格難易度認定試験にもっと自信を増加して、もし失敗したら、全額で返金いたします。 RadiatoripermotoriのCiscoの350-401資格難易度試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。

CCNP Enterprise 350-401 私の夢は最高のIT専門家になることです。

購入した前の無料の試み、購入するときのお支払いへの保障、購入した一年間の無料更新Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格難易度試験に失敗した全額での返金…これらは我々のお客様への承諾です。 しかも１００パーセントの合格率を保証できます。RadiatoripermotoriのCiscoの350-401 認証試験試験トレーニング資料を手に入れたら、あなたは自分の第一歩を進めることができます。

Radiatoripermotoriは多くの受験生を助けて彼らにCiscoの350-401資格難易度試験に合格させることができるのは我々専門的なチームがCiscoの350-401資格難易度試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの350-401資格難易度試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。

Cisco 350-401資格難易度 - きっと君に失望させないと信じています。

このインターネット時代において、社会の発展とともに、コストがより低くて内容が完全な情報が不可欠です。弊社の350-401資格難易度問題集は他のサイトに比べて、試験の範囲をカバーすることはより広くて、合理的な価格があります。しかしも、品質はもっと高くて一度350-401資格難易度試験に合格したい客様に対して、我が社の350-401資格難易度はあなたの最高選択かつ成功のショートカットであると思われます。

我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。Radiatoripermotori Ciscoの350-401資格難易度試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。

350-401 PDF DEMO:

QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確のOracle 1Z0-1072-25-JPN試験問題集を開発するのに準備します。 RadiatoripermotoriのCiscoのSalesforce Service-Cloud-Consultantトレーニング資料即ち問題と解答をダウンロードする限り、気楽に試験に受かることができるようになります。 今はCisco　ITIL ITIL-4-Specialist-Create-Deliver-and-Support試験に準備するために、分厚い本を購買しなくてあまりにも多くのお金をかかるトレーニング機構に参加する必要がありません。 Fortinet FCSS_NST_SE-7.4 - Radiatoripermotoriはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。 あなたのCisco　Google Google-Workspace-Administrator-JPN試験に合格するのは我々が与えるサプライズです。

Updated: May 28, 2022