Radiatoripermotoriが与えた道に沿って、あなたの成功への独自の道に行くことができるようになりますRadiatoripermotoriはCiscoの350-401受験対策解説集認定試験に関する包括的な資料を提供します。当社のトレーニング資料は専門家が研究した最新の研究資料です。 周りの多くの人は全部Cisco　350-401受験対策解説集資格認定試験にパースしまして、彼らはどのようにできましたか。今には、あなたにRadiatoripermotoriを教えさせていただけませんか。 選択は必ずしも絶対な幸福をもたらさないかもしれませんが、あなたに変化のチャンスを与えます。

CCNP Enterprise 350-401 最もよくて最新で資料を提供いたします。

それはRadiatoripermotoriのように最良の350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)受験対策解説集試験参考書を提供してあなたに試験に合格させるだけでなく、最高品質のサービスを提供してあなたに100％満足させることもできるサイトがないからです。 Cisco 350-401 学習資料「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格することが簡単ではなくて、Cisco 350-401 学習資料証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。

すなわちRadiatoripermotoriの350-401受験対策解説集問題集を利用して試験の準備をすることです。350-401受験対策解説集認定試験を受験したいですか。350-401受験対策解説集認証資格を取得したいですか。

Cisco 350-401受験対策解説集 - その夢は私にとってはるか遠いです。

あなたは今Ciscoの350-401受験対策解説集試験のために準備していますか。そうであれば、あなたは夢がある人だと思います。我々Radiatoripermotoriはあなたのような人に夢を叶えさせるという目標を持っています。我々の開発するCiscoの350-401受験対策解説集ソフトは最新で最も豊富な問題集を含めています。あなたは我々の商品を購入したら、一年間の無料更新サービスを得られています。我々のソフトを利用してCiscoの350-401受験対策解説集試験に合格するのは全然問題ないです。

さて、はやく試験を申し込みましょう。Radiatoripermotoriはあなたを助けることができますから、心配する必要がないですよ。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

我々RadiatoripermotoriのITエリートと我々のCiscoのVMware 2V0-11.25試験のソフトに満足するお客様は我々に自信を持たせます。 RadiatoripermotoriのHuawei H13-222_V1.0教材を購入したら、あなたは一年間の無料アップデートサービスを取得しました。 一番優秀な資料を探すのは大変ですか？CiscoのJuniper JN0-281試験に合格するのは難しいですか？我が社RadiatoripermotoriのJuniper JN0-281を通して、これらの問題を簡単に解決できます。 Radiatoripermotoriはあなたが必要とするすべてのWGU Scripting-and-Programming-Foundations参考資料を持っていますから、きっとあなたのニーズを満たすことができます。 あなたの支持こそ我々は最も高品質のCisco　IIBA ECBA-JPN問題集を開発して努力します。

Updated: May 28, 2022